tag:blogger.com,1999:blog-3604425971259502766.post4102661172138960272..comments2011-09-02T02:37:09.619+02:00Damon Kohlerhttps://profiles.google.com/111315168223845673859noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-3604425971259502766.post-19358062058836850642011-09-02T02:37:09.619+02:002011-09-02T02:37:09.619+02:00You rock!!!! I read about some longer, more complicated fixes for the diagnostic mode - all lights flashing in sequence problem, but didn&#39;t feel confident about slicing open the top or taking it apart, etc. I tried your fix and it worked the first time! I didn&#39;t feel any moisture under the sticker or on the power button or clean button sensors, but I wiped them off, then carefully replaced the sticker and put the bumper back on. It started up right away. Thank you SO MUCH!!!!<br /><br />LesaLesa Whaleyhttp://www.blogger.com/profile/13236588140710935202noreply@blogger.comtag:blogger.com,1999:blog-3604425971259502766.post-13691940893195857912011-05-12T20:03:40.914+02:002011-05-12T20:03:40.914+02:00It Worked!!! Now I have the new one and the fixed one ;) By the way thank you very much![e]http://www.blogger.com/profile/10371353924541151222noreply@blogger.comtag:blogger.com,1999:blog-3604425971259502766.post-50311355615823724492009-04-14T03:31:00.000+02:002009-04-14T03:31:00.000+02:00IT WORKED. I use my scooba all the time and one month after the warranty expired the "Scooba Stuck In Diagnostic Mode" problem started. I followed the steps and my scooba is cleaning as I type. I am so glad it was really quick and easy too. The whole process only took about 20 min. Thank You damonkohler much appreciated.BigMikehttp://www.blogger.com/profile/15546511615839459537noreply@blogger.comtag:blogger.com,1999:blog-3604425971259502766.post-62785605897910649422008-12-26T07:35:00.000+01:002008-12-26T07:35:00.000+01:00Awesome, worked for me!<BR/><BR/>Although some minor differences, never used the scooba, so water/moisture wasn't the culprit here, did the 5 beeps and then 4 beeps all lights flashing. But it was the clean button being stuck on and entering into diag mode. <BR/><BR/>I ended up putting little pieces of rubber underneath the power and clean buttons, so they would spring back into the off position. Appears that the manufacture was a little to liberal with the glue that held down the front panel. Some of it leaked over and caused the clean button to be in a constant open state. <BR/><BR/>Those crappy button never seem to work right, somewhat disappointed with roomba for using such a flawed design. (almost as bad as the front wheel on roomba vac).zerobanehttp://www.blogger.com/profile/02697581877888477497noreply@blogger.com